3D Scope II Mounting Bracket (LC & HC)

Table of Contents

    Overview

    This article provides information about installation and usage of the SMS approved counter bracketing hardware available for purchase.

    m

    Tools and Material Required

     

    How to assemble and mount the bracket

    18" Bracket

     

    54" Bracket

     

    X-Mount Adapter for 3D SCope II LC

     

     

    How to assemble 18" bracket  (Pole Cam)

    1. Assemble the Arm Mount with the U shape bracket

    Parts Needed

     

    2. Mounting the U shape bracket to the arm mount 

     

     

    The Arm mount should now resemble the following 
     

    3. Assemble the Arm mount and the camera bracket

    Parts needed

    4. Mounting the Camera  bracket to the arm mount 

    5. Mounting the 3D Camera mount to the Bracket

            Parts needed 

    Installation

                A. Loosen the 4 screws to allow the bracket arm to be easily adjustable to the 3D frame

            B. Align the bracket arm with the 3D Frame and mounting together using the screws, washer and nuts. (Doing one arm at a time might be easier)

    Inside View

     

    Top View

     

     

    4. Mounting Bracket is now completed

    Assembly Without the 3D Camera

    Assembly with the 3D Camera

     

     

    How to assemble 18" bracket
    1. Select an appropriate location for the ceiling plate. Typically where the cable will be run.*Note: Minimum 2 holes are required to secure the bracket.
    2. Mount and Secure the plate.  *Note: For a closed ceiling the cable hole would typically be in the middle of the plate
    3. Fasten Extension Pipe to Ceiling Plate (Optional) Can be mounted directly to Ceiling Plate without extension pipe.  Always verify scope of work or counter installation manual to determine at what height the device should be mounted for accurate counting.
    Click to Zoom
    Click to Zoom
    1. Connect and secure the extension pipe (Optional) Additional Extension Pipe may be used. MAX LOAD total of 3 pipes. Can be interconnected and Fastened. 
    Click to Zoom
    Click to Zoom

    Click to Zoom
    1. Connect the Mounting Plate to the Extension Pipe

    Click to Zoom

    Click to Zoom


     

    1. Connect the counter to the mounting plate

    Click to Zoom

    Click to Zoom

    Click to Zoom
    1. Route cable though the interior of the pipe and tie wrap any loose to the mounting plate.

    Click to Zoom

    Click to Zoom
    Open Deck Ceiling Type No Extension pole